When we come to someone's house, the first ineye rushes flooring. The beauty and cosiness of the house largely depend on its appearance and quality characteristics, so it is not recommended to save on the flooring. However, the cost of good material is sometimes such that willy-nilly you want at least to save something.
Deciding to put the laminate yourself, it's importantstock up time and patience, because this process is quite labor-intensive (like any major repairs, by the way speaking). It is very important to prepare the floor surface. It should be as flat as possible, without strong swings and bumps. If you use warm floors in the form of film infrared heaters, especially "wise" does not have to. But when choosing water heating systems will have to make a quality screed. Here it is necessary to make a digression and say that it is better to entrust the screed to professionals, since it must be laid perfectly smoothly. It should be noted that the warm floor under the laminate, the reviews speak for themselves, involves the use of the highest quality and resistant to the impact of the external environment of the laminate.
Laying of laminate boards depends onlocation in the window room. It is desirable to have the laminate perpendicular to the window, in which case the seams on it will be the least noticeable. It is important to note that to lay a laminate under a warm floor you need to maximally qualitatively glue the seams, otherwise the joints between the panels may disperse due to temperature differences.
Determining with the direction of laying, we preparenecessary tools: jig saw (for sawing an unnecessary remainder of the board), a pencil, spacers 1-2 cm thick. Spacers these put around the perimeter of the room near the wall, as they give room for maneuvering at the unevenness of the room. You will also need a wooden bar and a hammer. As you can see, the warm floors under the laminate (the price of which, by the way, has recently decreased), practically do not limit you in the choice of materials and methods of work.
We stack the first board and from the front sidewe bring the second. Laying is done on the principle of a comb-groove, and the reliability of each connection must be checked individually. Take the wooden bar and apply it to the end of the second board over the groove, knock on it with a hammer. Thus, we provide a tight grip between the laminate plates. In this sequence, lay out a series. Each board in the following rows will be interlocked on four sides, so the quality of the connection must be paid the most attention.
In short, lay the laminate under the warm floor should be in the usual manner.
</ p>